Questions in 2015 to 2017
FAQ in 2015 to 2017
Page 7 out of 15 Pages
- Q10021605 - Is there a way to tell RAID controller hardware revision in software?
(11124 views) - Q10011605 - CLI is showing garbage Slot# larger than 32 when the Disk Info command is issued to HGST JBOD 4U60.
(9319 views) - Q10051603 - Set "HDD Low power Idle" to "7" and test. Then reset to "Disabled" again, but the setting is stuck.
(7473 views) - Q10041603 - ARC-1882ix/4GB with battery is suddenly powered off. It is shown F/W detects: ** SDRAM speed not enough!!** on screen before get into OS.
(10898 views) - Q10031603 - The Innodisk 2.5” SATA SSD 3MG2-P is not being detected or detected intermittently while using our MB996SP-6SB with ARC-1883IX-12 Controller.
(10631 views) - Q10021603 - CentOS 7.2 benchmark is lower than CentOS 6.5 with Areca default driver.
(10187 views) - Q10011603 - For ARC-1883/ARC-1882/ARC-12x3 RAID Controllers, are the Linux drivers for RHEL 6.6 and 7.0 uEFI Aware? And, are the drivers signed with a trusted key for a Linux uEFI boot with Secure Boot enabled?
(13164 views) - Q10041602 - Is it possible to boot from 4k native on Areca RAID controller?
(12132 views) - Q10031602 - Does Areca RAID controller BIOS support auto-selection for Option ROM?
(12010 views) - Q10021602 - ST4000NM0033 Seagate enterprise HDD can’t pass self test of ARC-1883ix-16 RAID controller shown randomly time out error, when system powers on.
(10917 views)
FAQ in 2015 to 2017