FAQ in 2013

Page 1 out of 2 Pages

• Q80061312 - ARC-5026 is too noisy for a desktop raid. Is it possible to reduce the fan noise?
  (4579 views)
• Q80051312 - Can we use the Archttp to manage only USB3.0 port in 5026 model?
  (4497 views)
• Q80041312 - When I force power the 5026 without any cable connected other than the power supply or USB 3.0 host connects only: it goes to and stays on the "start the kernel" message.
  (3071 views)
• Q80031312 - I Have been getting error messages when I connect my Mac Pro to my ARC-8050. The LED reads Fan #! Failure. The fan appears to be running when I looked at the back.
  (5036 views)
• Q80021312 - I see the limited number USB 3.0 volumes on ARC-5026. If using the Thunderbolt side only you can have 128 volumes. Any one of the Thunderbolt volumes can be marked as SCSI CH:0/LUN:0/ID:0 and only that volume can be shared with USB 3.0 side.
  (4879 views)
• Q80011312 - ARC-5026 works fine with thunderbolt, but when connected via USB 3.0, none of the partitions I've made shows.
  (4779 views)
• Q80031311 - Is ARC-8050 volume bootable via Thunderbolt?
  (5068 views)
• Q80021311 - After updating ARC-8050 boot, firm, and mbr0 bin files to 1.52 version using ethernet port, the unit can't boot up during the reboot, all three LED flashing with LCD panel shown "-" only.
  (2829 views)
• Q80011311 - I couldn't get Mac OS X Mavericks boot from the raid volume on both 8050 and 5026, both thunderbolt failed. However, with the same raid volume, it boots no problem with USB 3.0 connection on 5026.
  (4604 views)
• Q10031311 - Under MAC PRO machine, update to firmware 1.52 all files , and then reboot，it can not boot from the original bootable volume on the RAID controller.
  (4833 views)

17

one category up