Questions in 2021 to 2024
Page 1 out of 5 Pages
- Q10052407 - ARC-1203-8i was working normally as a normal Vmware power on. It has a warm boot problem with a controllerARC-1203-8i and a Supermicro X13sei-tf MB.
(45 views) - Q10042407 -After updating the ARC-1686-2NOD card to 1.69, the fan remains very high (around 6300 RPM). Is this normal?
(76 views) - Q10032407 -Will the ARC-1886-8X8I work with 2 SAS Cables attached to a dual expander JBOD?
(45 views) - Q10022407 -Supermicro X13-DAI-T is experiencing an issue when Areca 1886-16i is connected. The motherboard is getting stuck on error code 92 DXE--BIOS PCI Bus Enumeration.
(93 views) - Q10012407 -The system fails to reboot with ARC-1886 RAID controller card and Supermicro X13DEI, regardless with configured disks or without. RAID function is OK from system cold start.
(68 views) - Q10012301 - Supermicro SYS-110P-WTR doesn’t detect the intel-3600 NVMe when using ARC-1886-16I (Firmware 1.63).
(40 views) - Q10022305 - Firmware version 1.67 deletes old version firmware NTP /SNMP/ Alert By Mail configuration all entered numbers and the user needs to fill in everything again.
(63 views) - Q10012305 - How to disable a virtual bootable disk (UEFI OS) for RAID controller ARCxxxxUEFI.BIN code to launch the McBIOS setup utility?
(66 views) - Q10032301 - ARC-1886-16I with Supermicro BPN-SAS3-LB16A-N10 can only get Micron_7450_MTFD_15363.0GB NVMe drives to work 16Gx1 speed not 16Gx4.
(84 views) - Q10022301 - I flashed the firmware to version 1.66 package then rebooted the machine, now it will only load the Areca setup utility and will not allow to boot into existed Windows. It continues to reboot into the same utility. Press F10 to reboot and it just goes back to the utility.
(48 views)