FAQ in 2010 to 2015

Page 2 out of 4 Pages

• Q60011203 - When ARC-5040 configure USB 3.0 and connect to computer, the access LED will be blinking by itself and it won't stop.
  (4191 views)
• Q60011202 - The ATTO H380 has wide port issue with SAS RAID subsystem, which limited its performance since it will only connect through 1 SAS lane. The H680 performance is lower than we have expected. Does H680 have the same issue with ARC-8040?
  (4264 views)
• Q60011312 – ARC-8040 with ARC1320-8X can not work using macnonraid_install_arcsas-20130819 under Mac OS X 10.9, but it can work with MAC 10.7。
  (4386 views)
• Q60011311 - How do I enable ARC-5040 USB 3.0? USB 2.0 works but when plugged in via USB 3.0 the access light only flashes. No device is made available to the OS.
  (4572 views)
• Q60011309 - ARC-5040 with the Esata Cable to Fujitsu Celsius R920 Computer (C600 chip set) instantly gets a BSOD on Windows 7 X64. BSOD always says "iastorA.sys" .
  (2762 views)
• Q10061412 - Controller fails the brand new hard drive when runs the Hdd Xfer Speed function.
  (4018 views)
• Q10031411 - Areca RAID controllers can only detect 10 HDDs with Quanta M4600H 60-bays JBOD.
  (4791 views)
• Q10021411 - Mac OS X Disk utility sees the new creation volume but doesn't allow any operation (erase or partition).
  (4397 views)
• Q10071410 - I'd like to know how to set and keep the clock settings for the PCIe RAID controller without using NIC. Everytime I look at the event log, the times are off, thus making the logs useless.
  (4307 views)
• Q10061410 - Does Areca firmware have day/time to program the Volume Check Scheduler?
  (4493 views)

37

one category up