FAQ in 2015 to 2017

Page 4 out of 15 Pages

• Q10031704 - How can I clear the ARC-1264il-16 internal drive serial numbers as "failed"?
  (4242 views)
• Q10021704 - When ARC-1883LP RAID6 with Blackmagic Ver 2.11 in Write through mode, Read is 0 MB/s. Write is at 224.3 MB/s.
  (5281 views)
• Q10011704 - Does ARC-1883x support a raid over 100TB?
  (6762 views)
• Q10031703 - Areca RAID Hierarchy shows disk drive numbering different from “Drive Location” label on the HGST JBOD 4U60.
  (7874 views)
• Q10021703 - ARC-1883ix cannot see any HDD when HGST JBOD 4U60 is set as SES mode.
  (7180 views)
• Q10011703 - Every time hot swap WD gold drive (WD4002FYYZ) drive on ARC-1203-8i, all other drives will be kicked out.
  (7608 views)
• Q10051702 - X9DR3-F (BIOS 3.2a) server will not start with ARC-1883i firmware version = V1.54-20161123, if there are two or more Volume Set. With 1 Volume Set server starts without problem.
  (7832 views)
• Q10041702 - Our custumer is running Supermicro X9DRL-iF (BIOS 3.0a) und Areca-1883 (Firmware 1.54 - 2016-11-23), booting hangs at Supermicro BIOS Message B2.
  (7246 views)
• Q10031702 - CLI 1.14.7 shows for ARC-1883CAP-FBM only "22% loaded" instead of «charged (18.4V)».
  (5455 views)
• Q10021702- ARC-1883 set to JBOD mode, after removing a disk, it would not beep.
  (6876 views)

144

one category up