Our ArcHTTP has supported HTTP management over SSL/HTTPS and/or SSH. Please click on Secure Connection (SSL) to enable the SSL function on the ArcHTTP Configuration screen. This function was added after ArcHTTP version 2.5.0-20171229
Tags: ARC-1883ix, Archttp- FAQ Home
- All categories
- SATA/SAS PCI RAID Card
- Mezzanine Board
- SAS Non-RAID Adapters
- External RAID Controllers
- JBOD/Expander Box
- Desktop RAID Subsystem
- Internal RAID Rack
- Thunderbolt Solutions
6 users online | 6 Guests and 0 Registered
Q10011801 - Is it possible to run HTTP management over SSL/HTTPS and/or SSH on ARC-1883ix?
- Last update:
- 2018-01-05 10:24
- Author:
- Simone
- Revision:
- 1.1
You cannot comment on this entry
Records in this category
- Q10011601 - Smartmontools can not interact with SAS devices on ARC-1224 RAID controller.
- Q10021601 - Is there a difference between ArcHTTPGUI and ArcHTTPSrvGUI?
- Q10031601 - Does Areca driver set the SCSI command timeout to 60 seconds running CentOS 5.5?
- Q10041601 - Which Linux driver source has included the ARC-1203 series adapter?
- Q10051601 - Which Linux kernel has included the ARC-1203 series adapter?
- Q10061601 - Which FreeBSD kernel has included the ARC-1203 series adapter?
- Q10071601 - Will ARC-1223-8X RAID controllers support the management by rs232 using Putty?
- Q10081601 - When ARC-1882ix-24 background initialization completes, progress of the initialization on the BIOS setup screen is stuck on xx% initializing displayed.
- Q10091601 - With ARC-1883LP installed HP Server DL380 gen9, the computer shows an error: Uncorrectable PCI Express Error (Embedded device, Bus 0, Device 0, Function 0, Error status 0x00000000).
- Q10101601 - When I try to use the ARC-1882, the HP DL385 G5P computer shows an error: “Fatal PCI Express Error PCI Slot 1 B42/D00/F00 10 “.
- Q10011602 - Is there any Red Hat Enterprise Linux 6.7 UEFI booting issue on x86, AMD64, and Intel 64 Systems?
- Q10021602 - ST4000NM0033 Seagate enterprise HDD can’t pass self test of ARC-1883ix-16 RAID controller shown randomly time out error, when system powers on.
- Q10031602 - Does Areca RAID controller BIOS support auto-selection for Option ROM?
- Q10041602 - Is it possible to boot from 4k native on Areca RAID controller?
- Q10011603 - For ARC-1883/ARC-1882/ARC-12x3 RAID Controllers, are the Linux drivers for RHEL 6.6 and 7.0 uEFI Aware? And, are the drivers signed with a trusted key for a Linux uEFI boot with Secure Boot enabled?
- Q10021603 - CentOS 7.2 benchmark is lower than CentOS 6.5 with Areca default driver.
- Q10031603 - The Innodisk 2.5” SATA SSD 3MG2-P is not being detected or detected intermittently while using our MB996SP-6SB with ARC-1883IX-12 Controller.
- Q10041603 - ARC-1882ix/4GB with battery is suddenly powered off. It is shown F/W detects: ** SDRAM speed not enough!!** on screen before get into OS.
- Q10051603 - Set "HDD Low power Idle" to "7" and test. Then reset to "Disabled" again, but the setting is stuck.
- Q10011605 - CLI is showing garbage Slot# larger than 32 when the Disk Info command is issued to HGST JBOD 4U60.
- Q10021605 - Is there a way to tell RAID controller hardware revision in software?
- Q10031605 - The ARC-1883ix appears to scroll though the disks in the Quanta M4600H JBOD until it hits the disk drive in slot 49.
- Q10041605 - The ARC-1883ix is hanging on a particular slot when booting the HGST 60 Bay. Removing and reinserting the drive in the particular slot to allow the ARC-8781 boot process to complete.
- Q10011607 - The ARC-1883ix expander gets mapping errors using show logs command when connect JBOD.
- Q10021607 - Do Areca RAID controllers support SED drive with encrypted function?
- Q10011608 - Is it possible to get an update in firmware that support SMTP with address instead of IP and be able to change port nr. SSL would also be awesome to get.
- Q10021608 - The event log data in ARC-1203-4i McBIOS RAID manager is abnormal shown as 2003-04.
- Q10031608 - The web browser GUI can not accept the password that sets on the McBIOS manager.
- Q10041608 - Supermicro X9DRD-7LN4F BIOS v3.2 will stuck at POST, when both ARC-1883i and ARC-1883X firmware updated to 1.53 2016-05-13. If only one alone, system passes POST and boots.
- Q10051608 - The HUH721010ALN600 10TB HDD is not power up and visible by ARC-1883ix bios on controller boot.
- Q10011609 - Is it completely impossible to read out the “Power On Hours” of a SAS HD with Areca CLI?
- Q10021609 - Seagate ST6000VX001 6TB can not detect on ARECA ARC-1264IL-16.
- Q10031609 - We need to remove the Guest account access on the RAID card GUI. (Username=Guest, Password=Guest)
- Q10011612 - ARC-1200 can't reboot on the MB which is "HD330-Q87" made by DFI.
- Q10021612 - We have ARECA1883iX + 91-1883BA-T00B Bat, From CLI I see > Battery Status: 22% after 24hod.charging.
- Q10031612 - DFI BT160 ATOM based MB with ARC-1200, system could not be boot up after install OS on it.
Tags
12Gb/s SAS expander 4KN drive Acronis Advanced Data Mirroring AJA Alert By Mail Configuration ALUA AOC API ARC-1035 ARC-1130 ARC-1200 ARC-1201 ARC-1202 ARC-1203 ARC-1210 ARC-1212 ARC-1213 ARC-1213-4i ARC-1214 ARC-1214-4I Arc-1214-8I ARC-1220 ARC-1221 ARC-1221x ARC-1222 ARC-1223 ARC-1223-8i ARC-1223-8X ARC-1224 ARC-1224-8I ARC-1225-8I ARC-1231 ARC-1231Ml ARC-1260 ARC-1261ML ARC-1264il-12 ARC-1264il-16 ARC-1280 ARC-1280ML ARC-12x3 ARC-12x4 ARC-12x5 ARC-1300 ARC-1300-4e ARC-1300-4i ARC-1300ix-16 ARC-1320 ARC-1320-8i ARC-1320-8x