FAQ in 2012 to 2013

Page 7 out of 11 Pages

• Q10021309 - ARC1223-8X can not detect by GA-B75-D3V（Rev1.1).
  (5414 views)
• Q10011309 - File "ARC1880BIOS.BIN" contained in Firmware V1.52 for the 1880/1213/1223 series fails to update using either DosFlash [V1.50] or ArcHttp [V2.3.4].
  (5568 views)
• Q10081308 - Is there a way to tell from the unix command line if the RAID controller is a -12, -16 or -24?
  (5609 views)
• Q10071308 - Would it be possible for you to provide a custom ESXi 5.x install image with arcmsr included?
  (5477 views)
• Q10061308 - We receive the error message when installing Archttp under the Mac 10.8.x for installer from an "unidentified developer".
  (3348 views)
• Q10051308 - I updated the ARC-1200 Windows XP (x86) driver to version 6.20.00.28 and in device manager. I also get one other device called "Raid dummy device other SCSI device" appearing in question mark which does not accept the driver.
  (5280 views)
• Q10041308 - Will the ARC-1224-8I work with Windows 2000?
  (6457 views)
• Q10031308 - The ARC-1213-4I not only supports to create RAID 6 volume with 3 disks, but now it allows users to install OS on it.
  (6487 views)
• Q10021308 - I got issue when I install Win 2012 using ARC-1213-4i, write through mode and 4x WD5003ABYX (3 for RAID 5 & 1 for hotspare). After completed the installation, the first time boot in the OS, the system shows DPC_WATCHDOG_VIOLATION error.
  (6315 views)
• Q10011308 - Install W2K8 on a two array partition of the ARC-1222. The driver loading and RAID volumes are now listed. Unfortunately, when I try to install (Disk 1 Partition 1, 232.8 GB, Type: System), Windows throws: “Setup was unable to create a new system partition or locate an existing system partition”.
  (6037 views)

104

one category up