FAQ in 2015 to 2017

Page 7 out of 15 Pages

• Q10021605 - Is there a way to tell RAID controller hardware revision in software?
  (6136 views)
• Q10011605 - CLI is showing garbage Slot# larger than 32 when the Disk Info command is issued to HGST JBOD 4U60.
  (4702 views)
• Q10051603 - Set "HDD Low power Idle" to "7" and test. Then reset to "Disabled" again, but the setting is stuck.
  (3393 views)
• Q10041603 - ARC-1882ix/4GB with battery is suddenly powered off. It is shown F/W detects: ** SDRAM speed not enough!!** on screen before get into OS.
  (5819 views)
• Q10031603 - The Innodisk 2.5” SATA SSD 3MG2-P is not being detected or detected intermittently while using our MB996SP-6SB with ARC-1883IX-12 Controller.
  (5791 views)
• Q10021603 - CentOS 7.2 benchmark is lower than CentOS 6.5 with Areca default driver.
  (5689 views)
• Q10011603 - For ARC-1883/ARC-1882/ARC-12x3 RAID Controllers, are the Linux drivers for RHEL 6.6 and 7.0 uEFI Aware? And, are the drivers signed with a trusted key for a Linux uEFI boot with Secure Boot enabled?
  (7987 views)
• Q10041602 - Is it possible to boot from 4k native on Areca RAID controller?
  (6856 views)
• Q10031602 - Does Areca RAID controller BIOS support auto-selection for Option ROM?
  (6923 views)
• Q10021602 - ST4000NM0033 Seagate enterprise HDD can’t pass self test of ARC-1883ix-16 RAID controller shown randomly time out error, when system powers on.
  (6090 views)

144

one category up