On our raid cards, the array configurations are stored in array member drives. and once a member fail, the array status/signature in rest members will be modified. If the previous failed drive becomes normal after power cycle, this drive will report an identical raidset. But it does not belong to the original raidset because the array signature in this drive is different from others. Although these two raidsets have same raidset name but the raidset status/signature are different. You can check the raid card event log history to find out which HDD had been failed before.
Tags: ARC-1200, Q10011504- FAQ Home
- All categories
- SATA/SAS PCI RAID Card
- Mezzanine Board
- SAS Non-RAID Adapters
- External RAID Controllers
- JBOD/Expander Box
- Desktop RAID Subsystem
- Internal RAID Rack
- Thunderbolt Solutions
8 users online | 8 Guests and 0 Registered
Q10011504 - ARC-1200 is operating in RAID-1. At the moment ARC-1200 has two same name raid sets: Degraded and Incompleted. How to verify which HDD contains the active raid?
- Last update:
- 2015-08-24 08:44
- Author:
- Simone
- Revision:
- 1.1
You cannot comment on this entry






Records in this category
- Q10011601 - Smartmontools can not interact with SAS devices on ARC-1224 RAID controller.
- Q10021601 - Is there a difference between ArcHTTPGUI and ArcHTTPSrvGUI?
- Q10031601 - Does Areca driver set the SCSI command timeout to 60 seconds running CentOS 5.5?
- Q10041601 - Which Linux driver source has included the ARC-1203 series adapter?
- Q10051601 - Which Linux kernel has included the ARC-1203 series adapter?
- Q10061601 - Which FreeBSD kernel has included the ARC-1203 series adapter?
- Q10071601 - Will ARC-1223-8X RAID controllers support the management by rs232 using Putty?
- Q10081601 - When ARC-1882ix-24 background initialization completes, progress of the initialization on the BIOS setup screen is stuck on xx% initializing displayed.
- Q10091601 - With ARC-1883LP installed HP Server DL380 gen9, the computer shows an error: Uncorrectable PCI Express Error (Embedded device, Bus 0, Device 0, Function 0, Error status 0x00000000).
- Q10101601 - When I try to use the ARC-1882, the HP DL385 G5P computer shows an error: “Fatal PCI Express Error PCI Slot 1 B42/D00/F00 10 “.
- Q10011602 - Is there any Red Hat Enterprise Linux 6.7 UEFI booting issue on x86, AMD64, and Intel 64 Systems?
- Q10021602 - ST4000NM0033 Seagate enterprise HDD can’t pass self test of ARC-1883ix-16 RAID controller shown randomly time out error, when system powers on.
- Q10031602 - Does Areca RAID controller BIOS support auto-selection for Option ROM?
- Q10041602 - Is it possible to boot from 4k native on Areca RAID controller?
- Q10011603 - For ARC-1883/ARC-1882/ARC-12x3 RAID Controllers, are the Linux drivers for RHEL 6.6 and 7.0 uEFI Aware? And, are the drivers signed with a trusted key for a Linux uEFI boot with Secure Boot enabled?
- Q10021603 - CentOS 7.2 benchmark is lower than CentOS 6.5 with Areca default driver.
- Q10031603 - The Innodisk 2.5” SATA SSD 3MG2-P is not being detected or detected intermittently while using our MB996SP-6SB with ARC-1883IX-12 Controller.
- Q10041603 - ARC-1882ix/4GB with battery is suddenly powered off. It is shown F/W detects: ** SDRAM speed not enough!!** on screen before get into OS.
- Q10051603 - Set "HDD Low power Idle" to "7" and test. Then reset to "Disabled" again, but the setting is stuck.
- Q10011605 - CLI is showing garbage Slot# larger than 32 when the Disk Info command is issued to HGST JBOD 4U60.
- Q10021605 - Is there a way to tell RAID controller hardware revision in software?
- Q10031605 - The ARC-1883ix appears to scroll though the disks in the Quanta M4600H JBOD until it hits the disk drive in slot 49.
- Q10041605 - The ARC-1883ix is hanging on a particular slot when booting the HGST 60 Bay. Removing and reinserting the drive in the particular slot to allow the ARC-8781 boot process to complete.
- Q10011607 - The ARC-1883ix expander gets mapping errors using show logs command when connect JBOD.
- Q10021607 - Do Areca RAID controllers support SED drive with encrypted function?
- Q10011608 - Is it possible to get an update in firmware that support SMTP with address instead of IP and be able to change port nr. SSL would also be awesome to get.
- Q10021608 - The event log data in ARC-1203-4i McBIOS RAID manager is abnormal shown as 2003-04.
- Q10031608 - The web browser GUI can not accept the password that sets on the McBIOS manager.
- Q10041608 - Supermicro X9DRD-7LN4F BIOS v3.2 will stuck at POST, when both ARC-1883i and ARC-1883X firmware updated to 1.53 2016-05-13. If only one alone, system passes POST and boots.
- Q10051608 - The HUH721010ALN600 10TB HDD is not power up and visible by ARC-1883ix bios on controller boot.
- Q10011609 - Is it completely impossible to read out the “Power On Hours” of a SAS HD with Areca CLI?
- Q10021609 - Seagate ST6000VX001 6TB can not detect on ARECA ARC-1264IL-16.
- Q10031609 - We need to remove the Guest account access on the RAID card GUI. (Username=Guest, Password=Guest)
- Q10011612 - ARC-1200 can't reboot on the MB which is "HD330-Q87" made by DFI.
- Q10021612 - We have ARECA1883iX + 91-1883BA-T00B Bat, From CLI I see > Battery Status: 22% after 24hod.charging.
- Q10031612 - DFI BT160 ATOM based MB with ARC-1200, system could not be boot up after install OS on it.
- Q10052009 - We use a ARC-1882i in JBOD mode and i noticed that it does not presents enclosure/slots to the system.
Tags
12Gb/s SAS expander 4KN drive Acronis Advanced Data Mirroring AJA Alert By Mail Configuration ALUA AOC API ARC-1035 ARC-1130 ARC-1200 ARC-1201 ARC-1202 ARC-1203 ARC-1203-2I ARC-1210 ARC-1212 ARC-1213 ARC-1213-4i ARC-1214 ARC-1214-4I Arc-1214-8I ARC-1220 ARC-1221 ARC-1221x ARC-1222 ARC-1223 ARC-1223-8i ARC-1223-8X ARC-1224 ARC-1224-8I ARC-1225-8I ARC-1230-8x ARC-1231 ARC-1231Ml ARC-1260 ARC-1261ML ARC-1264il-12 ARC-1264il-16 ARC-1280 ARC-1280ML ARC-12x3 ARC-12x4 ARC-12x5 ARC-12x6 ARC-1300 ARC-1300-4e ARC-1300-4i ARC-1300ix-16